X
تبليغات
The posts are 1x2s. Partially drill a short screw

conical screw barrel

The posts are 1x2s. Partially drill a short screw


new pressure treated wood (ACQ) in the garden argument by using regular lumber. You could use 2x4s but 1x2s are cheaper and theyre strong enough to support the weight of most veggies so why not save a few dollars. These screws are for attaching your twine.

The posts are 1x2s. Partially drill a short screw with a large head (or add a washer) into each mark.

I avoid the whole old pressure treated wood (CCA) vs. Its going to rot in a few years, but at $1.88 for an 8 foot 1x2, Id rather replace the wood instead of worrying about chemicals leaching into the soil. Will they or wont they? Thats a question for someone conical screw barrel else. If you keep knocking the cross piece off, single screw and barrel then duct tape it. Fasten the string going horizontally across the trellis and then going vertically, screwing the screws in as you go.

Each post should be buried at least 18 deep or if youre building a trellis that will go inside a raised bed like mine, then you can secure it to the frame with 2 more screws.. Remember that youll want the two posts to be the same height so that the cross piece is level. When going from top to bottom, tie a knot in the twine every place that it crosses the horizontals. Space is limited in my garden raised beds, so I have to garden vertically when I can and make use of every square inch. The cucumbers would need room to grow and I needed to build a trellis.

If youre looking for a fancy trellis made by a woodworker or someone who can bend and twist wrought iron to make art, then youll have to look elsewhere. As I said before, my trellis may not look good enough for a gardening magazine but it sure did the job. Once youre level, use two 3 inch galvanized screws to secure each joint.

After enjoying a nice harvest of cucumbers this summer, I was very happy with the results of this garden project. This is a quick and easy trellis made from wood and twine. Youll need two 1x2s to use as posts and one as a cross piece that goes across the top. If you dont have a laser level then place the cross piece on top and use a regular bubble level. Use a hammer to slowly tap the posts into the ground. A laser level is a great tool to easily accomplish this. This year, I decided that squash and cucumbers would share a 4x8 bed. If youre worried about the wood cracking, then pre-drill your holes.

Now measure and make pencil marks one foot apart going down from the top and then along the cross piece. Tie a knot around the first screw and then screw it in the rest of the way so that the twine is secure
موضوع :
برچسب ها : bimetallic screw barrel,

+ نوشته شده در 1397/12/29ساعت 5:27 توسط conical screw barrel | تعداد بازديد :19 |

عناوين مطالب پربازدید
You do not need to be a scientist to be able to make
Inspecting the studs as the cleats are cleaned
The posts are 1x2s. Partially drill a short screw